omron — APPENDIX F Serial Commands

Appendix F Serial Commands JOBINFO [[-slot=]n] [-v] Gets job summary or info about slot n . JOBINFO with no arguments returns a list of all jobs on the device. -v = Verbose n . This option shows the amount of space that would be freed if the job were deleted. It also lists the total disk space and free disk space. JOBLOAD {[-slot=] |-mem} [-r] Loads a job from slot n or from memory when used with the JOBDOWNLOAD command via FTP. -r = Start inspections. JOBSAVE [-slot=] Saves current job to slot n . MEMAVAIL [-cp] Returns available memory for device or coprocessor. MEMCONTIG [-cp] Returns maximum memory block for device or coprocessor.

MEMFRAGS [-cp] Returns memory fragments for device or coprocessor. Important: MEMFRAGS is not supported by the HAWK MV-4000. It will return !ERROR . MEMINFO [-cp] [-v] Returns memory summary “avail/contig/frags” for device or coprocessor. Verbose. OFFLINE Stops all inspections. ONLINE Starts all inspections. ONLINE? [-insp=n] Queries if each inspection on the camera is online. Defaults to all inspections if no inspection is specified. If the camera is running in a multi-inspection job, this command will return !1 if all inspections are online and !0 otherwise. -insp=n specifies the inspection to query if it is online. QUERYAUTOCAL Returns photometry settings: Gain, Exposure, and Focus.

F-6 HAWK MV-4000 Smart Camera Guide