Basic Waveform Output EN 7. Press Edge Time softkey to enter the edge time submenu. Press Leading softkey to highlight it. Use the numeric keypad to enter the value "75", then select the unit "nsec" from the menu that pops up. 8. Press Edge Time softkey to enter the edge time submenu. Press Trailing softkey to highlight it. Use the numeric keypad to enter the value "100", then select the unit "nsec" from the menu that pops up. 9. Press [Output1] button on the front panel to turn CH1 Output on. Figure 5.3 Setting Interface At this point, the specified waveform is output from CH1 based on the current configuration.
Connect the CH1 output terminal to the oscilloscope and the waveform is as shown in the figure below. Figure 5.4 Output Waveform Copyright © Qingdao Hantek Electronics Co., LTD HDG3000B User manual 25