Arbitrary Waveform Output EN 6 Arbitrary Waveform Output HDG3000B can output the built-in waveforms and user-defined arbitrary waveforms from a single channel or from two channels at the same time. The 160 kinds of built-in waveforms are stored in the internal non-volatile memory. The user-defined arbitrary waveforms can contain 64 to 2M data points. Users can edit the arbitrary waveforms via the PC software and then download them to the instrument. This chapter introduces how to configure the generator to output arbitrary waveforms. 6.1 Enable Arbitrary Waveform Press [Wave] > Arb softkey to enable the arbitrary waveform function and open the operation menu of the arbitrary waveform.
Figure 6.1 Arbitrary Interface To set the basic parameters of arbitrary waveforms, refer to “Set the Parameters”. Type: Select the built-in waveforms or user-defined arbitrary waveform stored in external storage. 6.2 Select Arbitrary Waveform The HDG3000B allows the user to select arbitrary waveform in the internal or external memory of the instrument for output. Press [Wave] > Arb > Type softkey to select the built-in waveform. Select more than 160 kinds of arbitrary waveform built in HDG3000B, as shown in the following table.
Press the softkey and select a type ("Math", "Project", "Distribution function" and "Trigonometric function", "Window function" and "biology"), and press the corresponding softkey type to select the desired waveform. Build-In Waveform HDG3000B User manual Copyright © Qingdao Hantek Electronics Co., LTD 26