Command system EN For example, OUTPut1 ON /* Enable the [Output1] connector */ OUTPut ? / * Returns ON if enabled*/ 3.18 PHASe subsystem The PHASe subsystem enables you to adjust the phase of the waveform. This is very useful in channel-channel and channel-sync applications. The subsystem also enables you to synchronize multiple instruments using 10 MHz Out and 10 MHz In rear panel connectors. 3.18.1 SOURce :PHASe Command format SOURce :PHASe |MINimum|MAXimum SOURce :PHASe? [MINimum|MAXimum] Function description Sets the starting phase of the waveform. Argument Instructions You can synchronize the phases of the two internal channels using PHASe:SYNChronize.
Return format Return the phase value as a scientific count. Example SOURce1:PHASe 90 /* Set the starting phase of channel 1 to 90 degrees */ 3.18.2 SOURce :PHASe:SYNChronize Command format SOURce :PHASe:SYNChronize Function description Copyright © Qingdao Hantek Electronics Co., LTD HDG300C Programming manual 47 Name Range Default value 0 to 360 degrees 0