Programming instance EN 4 Programming instance 4.1 Configure the sine wave This section will illustrate how to configure the sine wave function. Instructions A sine wave has amplitude, offset, and phase with respect to a synchronous pulse. Instance The following waveforms can be set by the SCPI command series: The following command will generate a sine wave as shown above: SOURce1:FUNCtion SINusoid SOURce1:FREQuency 100000 SOURce1:VOLTage 2 OUTPut1 ON SOURce1:PHASe 90 4.2 Configure the square wave Instructions A square wave has amplitude, offset, and phase with respect to a synchronous pulse. It also has a duty cycle and a period.
Its amplitude and offset can be set by high and low voltage values. Instance The following waveforms can be set by the SCPI command series: The following commands will generate a square wave as shown above: Copyright © Qingdao Hantek Electronics Co., LTD HDG300C Programming manual 69