Hantek — 8.8.1 Select BPSK Modulation

Modulation EN modulating signal from the [FSK/Trig/Sync/Extmod] connector on the rear panel. Note: The [FSK/Trig/Sync/Extmod] connector is different when controlling PSK and AM/FM/PM modulations externally. 8.7.5 PSK Rate When internal modulation source is selected, press [Mod] > Rate softkey to set the rate at which the output phase shifts between "carrier phase" and "modulation phase". ⚫ Use the numeric keypad or direction keys and knob to input the desired rate value. ⚫ The rate range is from 2mHz to 1MHz and the default is 100Hz. Note: This menu will be grayed out and disabled when the external modulation source is selected.

8.7.6 Modulation Phase Press [Mod] > Phase softkey to set the modulation phase. ⚫ Use the numeric keypad or direction keys and knob to input the desired phase ⚫ The phase range is from 0є to 360є and the default is 180є. value. 8.8 BPSK Modulation Users can configure the instrument to "shift" its output phase between two preset values using BPSK modulation. The rate at which the output shifts between the two phases (called the "carrier phase" and the "modulation phase") is determined by the internal signal level of the instrument. 8.8.1 Select BPSK Modulation Press [Mod] > Type > BPSK softkey to enable the BPSK function. ⚫ When Mod is enabled, Sweep or Burst will be disabled automatically.

⚫ After BPSK is enabled, the instrument will generate BPSK waveform with the currently specified carrier and modulating waveforms. To avoid multiple waveform changes, enable modulation after configuring the other modulation parameters. Copyright © Qingdao Hantek Electronics Co., LTD HDG3000C User manual 49