Modulation EN 8.8.2 Carrier Waveform Shape BPSK carrier shape: Sine (default), Square, Ramp, Pulse, Arbitrary (except DC) or Harmonic waveform. ⚫ Press [Wave] button on the front panel to select the desired carrier waveform. ⚫ Noise and DC could not be used as carrier waveform. 8.8.3 Carrier Waveform Phase Press [Setting] > Phase softkey on the front panel and use the numeric keypad or direction keys and knob to input the desired phase. The available phase ranges from 0є to 360є and the default value is 0є. 8.8.4 Modulation Source BPSK uses internal modulation source.
After enabling BPSK modulation function, press [Mod] > Data Source softkey, and select 01 code, 10 code, PN15 code or PN21 code as the modulation source. The default data source is 01 code. 8.8.5 BPSK Rate When internal modulation source is selected, press [Mod] > Rate softkey to set the rate at which the output phase shifts between "carrier phase" and "modulation phase". ⚫ Use the numeric keypad or direction keys and knob to input the desired rate value. ⚫ The rate range is from 2mHz to 1MHz and the default is 100Hz. 8.8.6 Modulation Phase Pressing [Mod] > Phase softkey to set the modulation phase. ⚫ Use the numeric keypad or direction keys and knob to input the desired phase values.
⚫ The phase range is from 0є to 360є and the default is 180є. 8.9 QPSK Modulation Users can configure the instrument to "shift" its output phase between four preset values using QPSK modulation. The rate at which the output shifts between the four phases (called the "carrier phase" and three "modulation phases") is determined by the internal signal level of the instrument. HDG3000C User manual Copyright © Qingdao Hantek Electronics Co., LTD 50