Hantek — 9.3 Center Frequency and Frequency Span

Sweep EN 9 Sweep In sweep mode, the instrument outputs the waveform that changes from the start frequency to the stop frequency at a specified sweep rate. HDG3000C supports linear sweep mode. Users can configure the instrument to output one sweep from start frequency to stop frequency by applying an external or manual trigger. The instrument can sweep sine, square, pulse, ramp, Harmonic or arbitrary waveforms (expect DC). 9.1 Select Sweep Press [Sweep] button on the front panel to enable the Sweep function (the backlight of the key goes on), and Mod or Burst function will be automatically disabled (if currently enabled).

To avoid multiple waveform changes, enable the sweep mode after configuring the other parameters (as waveforms and amplitudes of basic waves). Press [Sweep] button again to close sweep mode. 9.2 Start Frequency and Stop Frequency The generator sweeps from the start frequency to the stop frequency and then returns back to the start frequency. ⚫ Start Frequency high frequency. ⚫ Start Frequency > Stop Frequency: the generator sweeps from high frequency to low frequency. ⚫ Start Frequency = Stop Frequency: the generator outputs with a fixed frequency. When [Sweep] is enabled, press Start Freq / Center Freq softkey to highlight the "Start Freq".

The "Stop Freq" in the Stop Freq / Freq Span softkey is also highlighted. Use the numeric keyboard or direction keys and knob to input the desired frequencies. By default, the start frequency is 100Hz and the stop frequency is 1KHz. Different sweep waveform corresponds to different start frequency and stop frequency range. For frequency parameters of different waveforms, please refer to "Frequency Characteristics" in Specifications. After modifying the frequency, the generator will restart to output the frequency sweep signal with the specified frequency.

9.3 Center Frequency and Frequency Span Users can also set the sweep frequency boundaries of the sweep using a center frequency and frequency span. Copyright © Qingdao Hantek Electronics Co., LTD HDG3000C User manual 59