Sweep EN ⚫ Center Frequency = (|Start Frequency + Stop Frequency|) / 2 ⚫ Frequency Span = Stop Frequency – Start Frequency When [Sweep] is enabled, press Start Freq / Center Freq softkey to highlight "Center Freq". The "Freq Span" in the Stop Freq / Freq Span softkey is also highlighted. Use the numeric keyboard or direction keys and knob to enter the desired frequency values. By default, the center frequency is 550Hz and the frequency span is 900Hz. Different sweep waveform corresponds to different center frequency and frequency span range and center frequency and frequency span are inter-related.
Define the minimum frequency of the waveform currently selected as F min, the maximum frequency as F max and Fm = (F min +F max) / 2. The range of center frequency is from F min to F max. For frequency parameters of different waveforms, please refer to "Frequency Characteristics" in Specifications. The range of the frequency span is influenced by the center frequency: Center frequency F m: frequency span range is ±2 Ч (center frequency - F min); Center frequency ≥ F m: frequency span range is ±2 Ч ( F max- center frequency). Take sine as an example. F min is 1μHz, F max is 160MHz and F m is about 80MHz. If the center frequency is 550Hz, the range of the frequency span is:
±2 Ч (550Hz – 1μHz) = ±1.099999998kHz; if the center frequency is 155MHz, the range of the frequency span range is: ±2 Ч (160MHz – 155MHz) = ±10MHz. After modifying the frequency, the generator will restart to output the frequency sweep signal with the specified frequency. Note: In large-scale sweep, the amplitude characteristic of the output signal might change. 9.4 Linear Sweep HDG3000C provides linear sweep type. The output frequency of the instrument varies linearly in the way of "several Hertz per second". The variation is controlled by "Start Freq", "Stop Freq" and "Swep Time".
9.5 Sweep Time Sweep time specifies the time required to sweep from the start frequency to the stop frequency. When [Sweep] is enabled, press Swep Time softkey and use the numeric keyboard or knob to change the sweep time. The default value is 1s and the settable range is from 1ms to 50Ks. HDG3000C User manual Copyright © Qingdao Hantek Electronics Co., LTD 60