Hantek — 9.9 Sweep Trigger Source

Sweep EN 9.6 Return Time Return time specifies the number of seconds to return from the stop frequency to the start frequency. When [Sweep] is enabled, press the Ret Time softkey and use the numeric keyboard or knob to change the return time. The default value is 1s and the settable range is from 1ms to 50Ks. 9.7 Hold Time The hold time specifies how long time the waveform stays at the stop frequency. When [Sweep] is enabled, press the Hold Time softkey and use the numeric keyboard or knob to change the hold time. The default value is 1s and the settable range is from 1ms to 50Ks.

9.8 Mark Frequency When the output signal frequency is less than the specified mark frequency, there will output the low level signal from the [FSK/Trig/Sync/Extmod] connector on the rear panel. When the output signal frequency is at or greater than the specified mark frequency, the signal outputs on the [FSK/Trig/Sync/Extmod] connector will change from low level to high level. When [Sweep] is enabled, press Tag Frequency softkey and use the numeric keyboard or the direction keys and knob to modify the mark frequency. The default value is 500Hz and the settable range is limited by the "Start Frequency" and "Stop Frequency".

9.9 Sweep Trigger Source The sweep trigger source could be internal, external or manual. The generator will generate a sweep output when a trigger signal is received and then wait for the next trigger signal. When [Sweep] is enabled, press Trig Src softkey to select internal , external or manual . The default is internal. ⚫ internal: The generator outputs continuous sweep waveform at a rate determined by the total of the specified sweep time, return time and hold time. ⚫ external: The signal generator receives the trigger signal from the [FSK/Trig/Sync/Extmod] connector on the rear panel. A sweep will be generated once the connector gets a TTL pulse with specified polarity.

To set the TTL pulse polarity, press Polarity to select "Positive" or "Negative". The default is "Positive". ⚫ manual: A sweep will be generated from the corresponding channel once you Copyright © Qingdao Hantek Electronics Co., LTD HDG3000C User manual 61