Sweep EN press [Trigger] at the front panel. 9.10 Trigger Output Edge In sweep mode, when "Internal" or "Manual" trigger source is selected, the generator will output a TTL compatible signal with specified edge from the [FSK/Trig/Sync/Extmod] connector on the rear panel. Internal and Manual Trigger: The generator outputs a Pulse waveform from the [FSK/Trig/Sync/Extmod] connector on the rear panel at the beginning of the Sweep. The trigger period depends on the specified frequency sweep time, return time, and hold time. When the output signal frequency is less than the specified mark frequency, there will output the low level signal from the [FSK/Trig/Sync/Extmod] connector on the rear panel.
When the output signal frequency is at or greater than the specified mark frequency, the signal outputs on the [FSK/Trig/Sync/Extmod] connector will change from low level to high level. External Trigger: The [FSK/Trig/Sync/Extmod] connector is used as the input terminal of external trigger signal and has no trigger output HDG3000C User manual Copyright © Qingdao Hantek Electronics Co., LTD 62