Hantek — 10.2 Burst Type

Burst EN 10 Burst The HDG3000C can output a waveform for a specified number of cycles, called a burst. It supports control of burst output by internal, external or manual trigger source; supports three kinds of burst types including N cycle, Infinite cycle and Gated. Burst is allowed with sine, square, ramp, pulse, Harmonic, noise (allowed only in gated burst mode) or arbitrary waveforms (except DC). 10.1 Select Burst Press [Burst] button on the front panel to enable Burst function (the backlight of the key goes on), and Mod or Sweep function will be automatically disabled (if currently enabled). To avoid multiple waveform changes, enable burst mode after configuring other parameters.

10.2 Burst Type This instrument could output three types of bursts, including N Cycle, Infinite Cycle and Gate. The default is N Cycle. Table 10.1 Table Burst type N Cycle Burst In N Cycle mode, the generator will output waveform with specified number of cycles after receiving trigger signal. Press [Burst] > Type softkey to select “N Cycle ”.

Copyright © Qingdao Hantek Electronics Co., LTD HDG3000C User manual 63 Burst Type Trigger Source Carrier Waveform N Cycle Internal/External/Manual Sine/Square/Ramp/Pulse/Harmonic/Arbitr ary waveform (except DC) Infinite External/Manual Sine/Square/Ramp/Pulse/Harmonic/Arbitr ary waveform (except DC) Gated Ext Sine/Square/Ramp/Pulse/Noise/Harmoni c/Arbitrary waveform (except DC)