HP — 4.0 Non-Code Errors

Remove head cover and inspect liquefier inlet No Yes Are both filaments present at drive wheel? No Yes Is there a short piece of filament in the liquefier inlet? No Yes Is there excess material inside the head? 1. Filament Missing at Drive Wheel 2. Filament Tail Left at Liquefier Inlet Enter head maintenance and try to extrude 6. Excess Material Inside Head No Yes Did both filaments extrude? 3. Filament Present but Won't Extrude Did model or support features fall over? No Yes 5. Part Geometry Failure 4. Intermittent LOE -109 H. Loss of Extrusion (LOE) Use flow chart to determine type of LOE, then follow the steps below. 1.

Filament Missing at Drive Wheel - Filament tube disconnected - Filament pulled back 1. Verify that filament tube is connected at all junctions. 2. High pull force on the material spool. a. Verify spool lid is inserted properly and not rubbing on carrier. b. Remove any debris from bottom of carrier. c. Filament is tangled on spool. Replace spool. 3. High pull force in filament tubes. a. Inspect filament tubes and Y block for debris. Remove debris. b. Inspect for kinked filament tubes. Replace filament tubes. c. Check for twisted feed tubes in energy chain. If twisted, replace filament tubes.