-110 1. Filament Tail Left at Liquefier Inlet - Broken Filament - Undetected EOF 1. Verify that filament tube is connected at all junctions. 2. High pull force on the material spool. a. Verify spool lid is inserted properly and not rubbing on carrier. b. Remove any debris from bottom of carrier. c. Filament is tangled on spool. Replace spool. 3. High pull force in filament tubes. a. Inspect filament tubes and Y block for debris. Remove debris. b. Inspect for kinked filament tubes. Replace filament tubes. c. Check for twisted feed tubes in energy chain. If twisted, replace filament tubes. 4. System did not detect end of filament (EOF). Cycle power.
If repeats, verify FP switch functions properly. Replace material bay if defective.