HP — 4.0 Non-Code Errors

-111 2. Filament Present but Won't Extrude - Spin out - Head Motor Doesn't turn 1. High pull force on the material spool. a. Verify spool lid is inserted properly and not rubbing on carrier. b. Remove any debris from bottom of carrier. c. Filament is tangled on spool. Replace spool. 2. High pull force in filament tubes. a. Inspect filament tubes and Y block for debris. Remove debris. b. Inspect for kinked filament tubes. Replace filament tubes. c. Check for twisted feed tubes in energy chain. If twisted, replace filament tubes. 3. Inspect model for excessive overfill. a. Toolpaths should not overlap by more than 50%. If so, reorient and reprocess STL. b.

If model curl has caused the part to contact the tip, reprocess part with less dense fill. Re-run tip Z cal if part is separating from supports 4. Check for loose heater block clamp screws. 5. Plugged Liquefier - replace tips. 6. Check idler wheel gap. 7. Check liquefier alignment. 8. Head idler spring is deformed or installed improperly. Replace head idler spring. 9. Possible head temperature issue a. Replace head board and TC Amp board. b. Replace toggle head assembly. 10. Head motor power wires or encoder failure - replace toggle head 11. In case of Z shift: a. Realign Z guide rods. See “Installing the Z stage” on page 327. b. Replace Z motor and leadscrew. c. Replace Z assembly.