HP — 4.0 Non-Code Errors

-114 I. Lights Chamber lights won't come on or are dim. (Unit is otherwise functioning normally) 1. Check and reseat connectors to the light bar. 2. Swap light bars to determine whether bad light bar or bad cable. 3. Lights are burnt out - replace light bars. 4. Light bar cable is bad - replace cable. J. Material/Unload Error 1. Material Error Filament error 1. Remove the carrier and verify material is coming out of the material guide. 2. Verify material pulls freely from the carrier. 3. Verify the material tubes are free of material 4. Reload material. 2. Material Error Filament blocked 1. Remove carrier and verify material pulls freely from carrier. 2.

Verify the material tubes are free of material. 3. Reload material. 3. Material Error Carrier invalid 1. Remove carrier and verify it is not empty. 2. Replace material spool. 4. Material Error Filament broken 1. Remove the carrier and verify material is coming out of the material guide. 2. Verify material pulls freely from the carrier. 3. Verify the material tubes are free of material 5. Load Error Filament blocked 1. Remove the carrier and verify material is coming out of the material guide. 2. Verify material pulls freely from the carrier. 3. Verify the material tubes are free of material 6. Load Error Purge failed 1.

Remove the carrier and verify material is coming out of the material guide. 2. Verify material pulls freely from the carrier. 3. Verify the material tubes are free of material 4. Check for and clear any excess material build up around the tips. 5. Material may be jammed in head. See “Material Jam” on page 80.. 7. Unload Error Unload failed 1. Remove the carrier and verify the material tubes are free of material. 8. Filament does not reach filament present switch. 1. Filament is being cut off too long at carrier. Less than 1/4" should be exposed 2. Filament slipped into guide tube. Make sure filament extends to the end of the guide tube. 3.

High pull force spool, refer to "filament slips at head" under LOE section. 4. Possible bad drive motor, replace material bay.