-116 K. Network Communication 1. System boots, but won't talk to network. 1. If using static - Wrong IP address, check that IP in machine and HP Designjet 3D Software Solution are the same. 2. If using static - Make sure the IP address is static on the customer's network. 3. If using static - Verify IP address and netmask are correct with IT administrator. 4. Switch from static network to dynamic network or vice versa. 5. Network Internal (Pigtail) cable bad. Plug network cable directly into SBC to test. 6. Network interface on SBC has failed - green LED on SBC should blink when system is pinged, or green LED stays on when network cable is unplugged. Replace the SBC. 7.
OS on hard drive maybe corrupt - replace the hard drive. 2. Cannot communicate using a crossover cable with XP Microsoft Small Business Server adds a piece of software called Firewall Client. This must be turned off. 1. From Control Panel open the Firewall Client Options dialog box, uncheck the box that says "Enable Firewall Client". 2. If using static - verify IP address, Netmask and default gateway are correct on workstation and printer.