HP — What happens during Power Up / Boot

5. System won't boot, no display after 5 minutes. 1. If system homes: Check LCD cable, if OK replace LCD 2. Immediately after power-up, the LCD backlight should turn on, then the display pixels should all turn dark briefly before returning to light (blank) again. If this does not happen, then the LCD is bad. If it does happen, then either the LCD, I/O card or PDB could be at fault. 3. Measure for 12VDC at the hard drive. If not present check 12VDC power supply, replace cable or supply as needed. 4. If system does NOT home: Power on for at least 10 minutes. If still no text, Cycle power at circuit breaker and wait 10 minutes. If system does not home, proceed to step 5. 5. Reseat the I/O card.

6. Connect a monitor and keyboard to the SBC. a. Does BIOS drive listing show HD as primary, if not reseat IDE ribbon cable on both ends, Verify red line is to the right. b. Disk Boot Failure shown on monitor, software not seeing the hard drive. Reseat IDE ribbon cable on both ends. Verify red line is to the right. c. Kernel Panic Init Failed shown on monitor. Replace hard drive. d. If monitor displays: /dev/hdaXX: UNEXPECTED INCONSISTENCY; Fans, lights and LCD backlight are operating NOTE: Replacement hard drive may take up to 45 minutes to boot.

RUN fsck MANUALLY *** An error occurred during the file system check *** Dropping you to a shell; the system will reboot *** when you leave the shell - Replace hard drive e. Disk Check Failed (CHKDSK). Replace hard drive. 7. Replace I/O Card. 8. Replace SBC. 9. Replace PDB. 6. System powers off after a few seconds. 1. Check for shorts in the AC input. (eg. circuit breaker, line filter board, AC input cabling) 2. Power switch is bad, replace power switch. 3. Verify DC power supply outputs are not shorted to ground. 7. System reaching temp, does not go to "Idle" screen and head hits into the right side of the machine 1. Substrate sensor broken. System is attempting to retract sensor.

Replace the sensor. -122