HP — What happens during Power Up / Boot

-128 6. Model filament not loaded Diagnostic details: Left square (SS) Upper layers - Built OK 1st layer - OK Right square (model) Upper layers - Missing or barely stuck to modeling base. 1st layer - Missing. No evidence of ABS extrusion 1. Load material 7. Support filament not loaded Diagnostic details: Left square (SS) Upper layers - Missing. No evidence of SS extrusion 1st layer - Missing. No evidence of SS extrusion Right square (model) Upper layers - Missing or barely stuck to modeling base. 1st layer - Missing. No evidence of SS extrusion 1. Load material 8. Continued difficulty calibrating 1. Replace Z motor 2. Replace XY table.

Failed bearings in the Y drive shaft possible root cause. S. Noise 1. Buzzing noise from XY motors 1. Replace XY motors 2. Replace XY table. Failed bearings in the Y drive shaft possible root cause.