-127 3. Support tip much lower than model tip Diagnostic details: Left square (SS) Upper layers - Built OK 1st layer - OK Right square (model) Upper layers - Missing or barely stuck to modeling base. 1st layer - OK 1. Add -.010 to Z offset value 4. Support tip much higher than model tip Diagnostic details: Left square (SS) Upper layers - Built OK 1st layer - OK Right square (model) Upper layers - Did not build completely. may be some wisps of model material. 1st layer - May be visible, but roughed up from the support tip 1. Add +.010 to Z offset value 5. Possible worn/bad tip shield Diagnostic details:
Left square (SS) Upper layers - Part built, but surface looks rough or looks OK but cal failed 1st layer - OK Right square (model) Upper layers - Part built, but surface looks rough or looks OK but cal failed 1st layer - OK 1. Replace tip shield