-126 R. Z Calibration Failure 1. First layer too deep into modeling base Diagnostic details: Left square (SS) Upper layers - Missing 1st layer - May be visible, but looks choked off. Etches may be visible in modeling base. Right square (model) Upper layers - Missing or barely stuck to modeling base. Part layer shifted. 1st layer - May be visible, but looks choked off. Etches may be visible in modeling base. 1. Add +.010 to Z offset value 2. First layer tip too high off modeling base Diagnostic details:
Left square (SS) Upper layers - Missing or barely stuck to modeling base 1st layer - Missing or barely stuck to modeling base Right square (model) Upper layers - Missing or barely stuck to modeling base 1st layer - Missing or barely stuck to modeling base 2. Add -.010 to Z offset value