HP — What happens during Power Up / Boot

-125 O. Power Down 1. Fails to shutdown. 1. Toggle the power switch again. Wait 5 minutes 2. Shut system off at the breaker. 2. Display indicates "Recovery after uncontrolled shutdown" 1. AC power was interrupted. Verify AC power is present at outlet, i.e. plug a known good item into outlet. 2. Bad power switch cable. 3. UPS malfunctioned, replace UPS. 3. Display indicates "Recovery after controlled loss of power" 1. AC power was interrupted. Verify AC power is present at outlet, i.e. plug a known good item into outlet. 2. UPS wiring is incorrect. Check wiring 3. UPS malfunctioned, replace UPS. 4. Shuts down immediately after the power switch is thrown. 1. Replace the SBC. 2.

Replace the PDB. 3. Replace power switch. 5. Shuts down after part is complete 1. Auto power down was enabled, normal operation. P. System VERY slow to reach temperature 1. Envelope takes unusually long (over 40 minutes) to reach temperature. 1. Verify all covers and panels are properly installed. 2. Envelope heater(s) bad. Check heater resistance - should be about 36 ohms. 3. Replace PDB 4. See error codes 14-14 and 18-01. Q. Calibration Issues 1. Tip offset cal part - support and model over .78" offset 1. Check that tip offset values are close to default values. default = 0.78, 0.00 2. Tip offset values change but do not take. 1.

Tip offset is changed in HP Designjet 3D Diagnostic Software and the change is stored correctly in the hard drive (verified by viewing the CFG file). When the tip offset _ part is run though, the offset does not change. Replace SBC.