HP — Removing the door solenoid

Installing the front panel 1. Align the front panel with the mounting holes. 2. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 6 mounting screws. 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 2 mounting screws behind the display panel. 4. Reinstall the display panel. See “Installing the display panel” on page 166 5. Close the chamber door. Door Solenoid Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. Removing the door solenoid 1. Remove the display panel. See “Removing the display panel” on page 165 2. Remove the front panel. See “Removing the front panel” on page 166 3.

Disconnect the door solenoid (DRSOL) cable by pressing down on the tab. See Figure 74. Figure 74: Door solenoid connector location Disconnect the DRSOL cable. 4. Push the solenoid pin out and down to remove from the mounting bracket. See Figure 75. -168