Figure 75: Removing the door solenoid Installing the door solenoid 1. Push the solenoid pin out and slide door solenoid into place on the mounting plate. 2. Reconnect the DRSOL cable. 3. Reinstall the front panel. See “Installing the front panel” on page 168 4. Reinstall the display panel. See “Installing the display panel” on page 166 Door Sensor Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. Removing the door sensor 1. Remove the display panel. See “Removing the display panel” on page 165 2. Remove the front panel. See “Removing the front panel” on page 166 3. Disconnect the DRSW cable. See Figure 76. Figure 76: Door sensor cable location Disconnect the DRSW cable. 4.
Gently pull the door sensor out of the mounting plate. See Figure 77. Figure 77: Removing the Door Sensor -169