HP — Opening the electronics bay

Electronics Bay Components The main circuit boards and power supplies for the printer are located in the electronics bay. Note: When reinstalling components in the Electronics Bay area note that cable J401 is unused. (Not connected) Lower Electronics Bay Cover Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. Hardware • 10-32 x 3 ⁄ 8 ” slotted screws (x3) Opening the electronics bay 2. Remove the side panels. See “Removing the side panels” on page 162 1. Remove the top panel. See “Removing the top panel” on page 161 3. Remove the filament tubes from the Y connectors by pushing down on the ring and pulling back on the filament tubes. See Figure 78. Figure 78:

Removing the filament tubes from the Y connectors 4. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 3 mounting screws on the top of the electronics bay cover. See Figure 79. -171