Figure 79: Electronics bay cover mounting screw locations Remove the 3 mounting screws 5. Gently pull the electronics bay cover down. See Figure 80. Figure 80: Electronics bay with cover lowered Closing the electronics bay 1. Gently push the electronics bay cover back in to the closed position. 2. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 3 mounting screws. 3. Reconnect the filament tubes to the Y connectors. 4. Reinstall the side panels. See “Installing the side panels” on page 164 5. Reinstall the top panel. See “Installing the top panel” on page 162 -172