HP — Removing the upper electronics bay cover

Upper Electronics Bay Cover Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. Hardware • 10-32x 3 ⁄ 8 ” slotted screws (x4) Removing the upper electronics bay cover 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, loosen but do not remove the top left and right mounting screws. See Figure 81. Figure 81: Upper electronics bay cover top mounting screw locations Loosen but do not remove the 2 mounting screws 4. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the bottom left and right mounting screws. See Figure 82. -173