HP — Removing the controller board

Controller Board Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Phillips screwdriver Hardware • 6-32 x 1 ⁄ 4 ” Phillips pan head screws (x6) Removing the controller board 1. Open the electronics bay. See “Opening the electronics bay” on page 171 2. Touch the metal plate of the electronics bay cover to discharge any static electricity. 3. Remove the 3 ribbon cables by pressing the tabs outward and gently pulling the ribbon cables out of the sockets. See Figure 88. Figure 88: Controller board ribbon cable locations Remove the 3 ribbon cables 4. Using a standard screwdriver, loosen the 2 screws that hold the diagnos- tics DB-9 cable in place.

Then gently pull the cable out of the connector. See Figure 89. -179