Figure 95: SBC display cable location Disconnect the Display cable Reinstalling the single board computer 1. Reconnect the display cable. 2. Using a standard screwdriver, tighten the display cable mounting screws. 3. Align the SBC with the mounting holes. 4. Using a Phillips screwdriver, reinstall the 4 mounting screws. 5. Reconnect the RJ-45 network cable. 6. Reconnect the SATA cable. 7. Reconnect the J2 power cable. 8. Reinstall the controller board. See “Installing the controller board” on page 181 9. Close the electronics bay. See “Closing the electronics bay” on page 172 Power Distribution I/O Card Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver.
• Phillips screwdriver Hardware • 6-32 x 1 ⁄ 4 ” Phillips pan head screws (x3) -184