HP — Removing the power distribution board

Power Distribution Board (PDB) Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Phillips screwdriver Hardware • 6-32 x 1 ⁄ 4 ” Phillips pan head screws (x12) • 10-32 x 1 ⁄ 2 ” slotted screws (x8) Removing the power distribution board 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Open the electronics bay. See “Opening the electronics bay” on page 171 4. Touch the metal plate of the electronics bay cover to discharge any static electricity. 5. Remove the I/O card. See “Removing the I/O card” on page 185 6.

Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 4 screws on the left and right side of the electronics bay and carefully slide the elec- tronics bay out of the printer about 3 inches (76mm). See Figure 100. -187