Figure 98: I/O card mounting screw locations Remove the 3 mounting screws 8. Gently pull the I/O card out from the power distribution board sockets. Installing the I/O card 1. Gently slide the I/O card in to the power distribution board sockets. 2. Verify the I/O card is seated properly by viewing the connection through the viewing slots. See Figure 99. Figure 99: I/O card viewing slot location I/O card connections 3. Using a Phillips screwdriver, reinstall the 3 mounting screws. 4. Reconnect the thermocouple to the back side of the I/O card. 5. Reconnect the 6 cables to the I/O card. 6. Close the electronics bay. See “Closing the electronics bay” on page 172 7. Reinstall the side panels.
See “Installing the side panels” on page 164 8. Reinstall the top panel. See “Installing the top panel” on page 162 -186