HP — Installing the power distribution board

Installing the power distribution board 1. Align the power distribution board with the mounting holes. 2. Using a Phillips screwdriver, reinstall the 12 mounting screws. 3. Reconnect the 10 cables to the front of the power distribution board. 4. Carefully slide the electronics bay out 3 inches (76mm) and reconnect the 4 cables to the back of the PDB. 5. Carefully slide the electronics bay back into position. 6. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 8 mounting screws on the left and right sides. 7. Reinstall the I/O card. See “Installing the I/O card” on page 186 8. Close the electronics bay. See “Closing the electronics bay” on page 172 9.

Reinstall the side panels. See “Installing the side panels” on page 164 10. Reinstall the top panel. See “Installing the top panel” on page 162 -190