HP — Installing the hard drive

Figure 107: Hard drive mounting bracket screw locations Remove mounting brackets Installing the hard drive 1. Using a Phillips screwdriver, reinstall the 2 mounting brackets. 2. Push the hard drive in the slots and down into position. 3. Using a Phillips screwdriver, reinstall the 4 mounting screws. 4. Reconnect the SATA cable. 5. Reconnect the power input cable. 6. Close the electronics bay. See “Closing the electronics bay” on page 172 7. Power up the printer. The printer may take up to 45 minutes to run the Check Disc command before you see anything on the display panel. 8. After the printer has rebooted and is idle, press Maintenance > System > Set Network. 9.

Select either Dynamic networking or Static networking. 10. If using Static networking, enter the printers IP Address, Default Gateway and Subnet Mask values. 11. From the PC, open the HP Designjet 3D Software Solution. 12. Connect to the printer. 13. Insert the printer firmware CD into the workstation CD drive. 14. From the Printer Services tab, click on the Update Software button. 15. Navigate HP Designjet 3D Software Solution to the Upgrade (.UPG) file on the printer firmware CD. 16. The printer will load, reboot and verify the upgrade. -193