Line Filter Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Phillips screwdriver Hardware • 6-32 x 1 ⁄ 4 ” Phillips pan head screws (x3) Removing the line filter 1. Open the electronics bay. See “Opening the electronics bay” on page 171 2. Touch the metal plate of the electronics bay cover to discharge any static electricity. 3. Remove L1-1 and N1-1 spade connectors from the right side of the board by pulling back on the connector. See Figure 108. Figure 108: L1-1 and N1-1 spade connector locations Disconnect the N1-1 spade connector Disconnect the L1-1 spade connector 4. Remove L2-1 and N2-1 Spade connectors from the left side of the board by pulling up on the connector.
See Figure 109. -194