HP — Installing the line filter

Figure 109: L2-1 and N2-1 Spade connector locations Disconnect the N2-1 spade connector Disconnect the L2-1 spade connector 5. Using a Phillips screwdriver, remove the 3 mounting screws. See Figure 110. Figure 110: Line filter mounting screw locations Remove the 3 mounting screws 6. Lift board and gently remove the line filter. Installing the line filter 1. Align the line filter with the mounting holes. 2. Using a Phillips screwdriver, reinstall the 3 mounting screws. 3. Reconnect the L2-1 and N2-1 spade connectors to the left side of the board. 4. Reconnect the LF2-P and LF2-N spade connectors to the right side of the board. 5. Close the electronics bay.

See “Closing the electronics bay” on page 172 -195