Circuit Breaker Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Phillips screwdriver Removing the circuit breaker 1. Open the electronics bay. See “Opening the electronics bay” on page 171 2. Touch the metal plate of the electronics bay cover to discharge any static electricity. 3. Remove the Load and CB1 spade connectors from the circuit breaker by pulling up on the connectors. See Figure 111. Figure 111: Load and CB1 spade connector locations CB1 Load 4. Remove the CB1 Line and CB2 spade connectors from the circuit breaker by pulling up on the connectors. See Figure 112. Figure 112: CB1 Line and CB2 spade connector locations CB1 Line CB2 -196