5. Squeeze the tabs on the circuit breaker and push through the electronics bay panel. See Figure 113. Figure 113: Removing the circuit breaker Press tabs and push the circuit breaker through the panel Installing the circuit breaker 1. Push the circuit breaker through the electronics bay panel until it locks in place. 2. Reconnect the CB1 and CB2 spade connectors to the circuit breaker. 3. Reconnect the Load and CB1 spade connectors to the circuit breaker. 4. Close the electronics bay. See “Closing the electronics bay” on page 172 AC Input Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Phillips screwdriver Hardware • 1 ⁄ 2 ” x 6mm Phillips pan head screws (x2) -197