HP — Removing the 24VDC Power Supply

7. Disconnect the J1 connector on the 24VDC power supply. See Figure 120. Figure 120: J1 cable location Disconnect J1 8. Disconnect J3 1 through 4 connectors using a Phillips screwdriver. Note the position of the wires for reinstallation. See Figure 121. Figure 121: J3 1 through 4 connector locations Disconnect J3 1 through 4 9. Close the rear panel of the electronics bay and remove the 2 board mounting screws using a Phillips screwdriver. See Figure 122. -202