24VDC Power Supply Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Phillips screwdriver Hardware • 10-32 x 3 ⁄ 8 ” slotted screws (x3) • 6-32 x 1 ⁄ 4 ” Phillips pan head screws (x2) Removing the 24VDC Power Supply 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the electronics bay. See “Removing the electronics bay” on page 175 4. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 3 rear elec- tronics bay mounting screws. See Figure 119. Figure 119: Rear electronics bay mounting screw locations Remove the 3 mounting screws 5.
Open the rear panel of the electronics bay. 6. Touch the metal plate of the electronics bay cover to discharge any static electricity. -201