HP — Installing the power switch

Figure 117: Power switch connector locations 8. Press the Power Switch tabs in and push it out of the housing. See Figure 118. Figure 118: Removing the power switch Press tabs to release Press tabs to release Installing the power switch 1. Push the power switch into place on the power switch housing. 2. Connect the yellow NC wire to the spade connector labeled “2a”. 3. Connect the green COM wire to the spade connector labeled “2”. 4. Connect the black SW3 wire to the spade connector labeled “1a”. 5. Connect the white SW2 wire to the spade connector labeled “3”. 6. Align the power switch housing with the mounting holes. 7.

Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 2 mounting screws. 8. Reinstall the left side panel. See “Installing the side panels” on page 164 9. Install the top panel. See “Installing the top panel” on page 162 -200