HP — Removing the Power Switch

Power Switch Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. Hardware • 10-32 x 3 ⁄ 8 ” slotted screws (x2) Removing the Power Switch 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the left side panel. See “Removing the side panels” on page 162 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 2 power switch housing mounting screws. See Figure 116. Figure 116: Power switch housing mounting screw locations Remove the 2 mounting screws 4. Remove the white SW2 wire from the spade connector labeled “3”. See Figure 117. 5. Remove the black SW3 wire from the spade connector labeled “1a”. See Figure 117. 6.

Remove the yellow NC wire from the spade connector labeled “2a”. See Figure 117. 7. Remove the green COM wire from the spade connector labeled “2”. See Figure 117. -199