Head Components Head Cooling Fan Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • 7 ⁄ 64 ” allen wrench. Hardware • 6-32 x 1 3 ⁄ 4 ” flat head cap screws (x2) Removing the head cooling fan 2. Remove the side panels. See “Removing the side panels” on page 162 1. Remove the top panel. See “Removing the top panel” on page 161 3. Remove the upper electronics bay cover. See “Removing the upper elec- tronics bay cover” on page 173 4. Disconnect the J258 cable by pressing the tab and pulling the connector apart. See Figure 133. Figure 133: J258 cable location Disconnect J258 5. Using a 7 ⁄ 64 ” allen wrench, remove the 2 mounting screws. See Figure 134. -210