HP — Removing the toggle head assembly

Toggle Head Assembly Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Cutters Hardware • Wire tie (x1) • 10-32 x 3 ⁄ 8 ” slotted screws (x7) • 10-32 x 1 ⁄ 2 ” slotted screws (x4) Removing the toggle head assembly 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the right side access panel mounting screws and remove the panel. See Figure 135. Figure 135: Right side access panel mounting screw locations Remove the 7 mounting screws. 4. Remove the head cover by pressing the tabs in and pulling the cover out- ward. See Figure 136.

-212