HP — Installing the toggle head assembly

Figure 146: Toggle head mounting screw locations Remove the toggle head mounting screws Remove the toggle head mounting screws 14. Slide the toggle head assembly out of the translator. Installing the toggle head assembly 1. Remove the tag from the new toggle head assembly and set aside for later use. 2. Align the 2 mounting posts with the 2 mounting holes and gently push the toggle head into position. 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 4 mounting screws. 4. Reconnect the 3 head motor cables to the back of the head board. 5. Replace the wire tie holding the head motor cables in place. See Figure 147. Figure 147:

Wire tie location Reinstall wire tie around the head motor 6. Reconnect the toggle sensor cable to the head board. 7. Gently reconnect the toggle sensor cable to the toggle sensor. 8. Reconnect the model and support heater cables to the head board. 9. Reconnect the model and support thermocouples to the TC Amp board. 10. Place the model and support thermocouple wires in the wire retaining clip. 11. Connect the model and support material tubes. -217