HP — Removing the substrate sensor

Substrate Sensor Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • 3 ⁄ 32 ” allen wrench. Hardware • Wire tie (x1) • 10-32 x 3 ⁄ 8 ” slotted screws (x7) • 4-40 x 1 ⁄ 4 ” slotted screws and # 4 split lock washer (x4) Removing the substrate sensor 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Using a 5 ⁄ 16 ” nut driver, remove the 7 right side access panel mounting screws. See Figure 149. Figure 149: Right side access panel mounting screw locations Remove the 7 mounting screws. 4. Disconnect the substrate sensor wire from the head board by pressing in on the tab and pulling outward.

See Figure 150. -220