Figure 155: Z foam level assembly mounting screw locations 4 mounting screws 8. Remove the Z foam level assembly and discard. Installing the Z Foam Level Assembly: 1. Remove the Z foam level bar from the assembly by pushing the actuator into the housing and pulling the bar to the right. 2. Align the housing with the mounting holes and use a 3 ⁄ 32 ” allen wrench to reinstall the 4 mounting screws and washers. 3. Insert the actuator and spring into the housing and push all the way up. 4. Slide the bar to the left and into the housing, when installed correctly the actuator will not come out of the housing. 5. Reinstall the Substrate sensor. See “Installing the substrate sensor” on page 222 6.
Reinstall the side panels. See “Side Panels” on page 162 7. Reinstall the top panel. See “Installing the top panel” on page 162 8. Reconnect the AC power cord, RJ-45 network cable and UPS cable (if used). 9. Power on the system. The system should reach Idle with no displayed errors. 10. Run a small test part and monitor system operation during build. -224