HP — Removing the toggle sensor

Toggle Sensor Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • 3 ⁄ 32 ” allen wrench. Hardware • 4-40 x 1 ⁄ 4 ” slotted screws (x2) Removing the toggle sensor 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the right side access panel. See Figure 156. Figure 156: Right side access panel mounting screw locations Remove the 7 mounting screws. 4. Gently disconnect the toggle sensor wire by pulling outwards. See Fig- ure 157. -225