Figure 157: Toggle sensor wire connector location Gently disconnect the toggle sensor cable 5. Using a standard screwdriver, remove the 2 toggle sensor mounting screws. See Figure 158. Figure 158: Toggle sensor mounting screw locations Remove the 2 mounting screws 6. Remove the toggle sensor. Installing the toggle sensor 1. Align the toggle sensor with the mounting holes. 2. Using a standard screwdriver, reinstall the 2 mounting screws. 3. Reconnect the toggle sensor wire to the toggle sensor. 4. Align the right side access panel with the mounting holes. 5. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the right side access panel mounting screws. 6.
Reinstall the side panels. See “Installing the side panels” on page 164 7. Reinstall the top panel. See “Installing the top panel” on page 162 -226