HP — Installing the toggle bar:

Installing the toggle bar: 1. Align the toggle bar with the translator and reinstall the washer over the bottom mounting post. See (Figure 167) Figure 167: Toggle bar alignment Reinstall washer Align toggle bar 2. Push the toggle assembly back into position. 3. Reinstall the lower washer and spring. 4. Using a 7 ⁄ 64 ” allen wrench, reinstall the lower spring screw. 5. Reinstall the upper spring and washer. 6. Using a 7 ⁄ 64 ” allen wrench, reinstall the upper spring screw. 7. Using a 7 ⁄ 64 ” allen wrench, reinstall the heat shield. 8. Reinstall the model tip (right side) and support tip (left side) by pushing up into place. 9. Using a 7 ⁄ 64 ” allen wrench tighten the tip mounting screws.

10. Reinstall the head cover. 11. Power the printer up. 12. Perform calibrations. See “Offset Calibrations” on page 338 -232