HP — Removing the head board

Figure 176: Disconnect the toggle sensor cable from the toggle sensor Gently disconnect the toggle sensor cable 12. Using a 1 ⁄ 4 ” nut driver or standard screwdriver, remove the toggle sensor cable retaining clips. See Figure 177. Figure 177: Toggle sensor cable retaining clip locations Remove the 2 toggle sensor cable retaining clips 13. Feed the toggle sensor cable out through the head board. See Figure 178. Figure 178: Removing the toggle sensor cable from the head board Feed toggle sensor cable through the head board 14. Disconnect the substrate sensor cable and filament motor cables from the rear of the head board by pressing the tabs in and pulling outward. See Figure 179. -237